Cisco MWR 2941 Command Reference Manual page 587

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Class police
police cir 500000 conform-burst 10000 pir 1000000 peak-burst 10000 conform-action
transmit exceed-action set-prec-transmit 2 violate-action drop
Traffic marked as conforming to the average committed rate (500 kbps) will be sent as is. Traffic marked
as exceeding 500 kbps, but not exceeding 1 Mbps, will be marked with IP Precedence 2 and then sent.
All traffic exceeding 1 Mbps will be dropped. The burst parameters are set to 10000 bytes.
Table 44
Table 44
Field
police
conform-action
exceed-action
violate-action
Multiple Traffic Policing Actions: Example
The following is sample output from the show policy-map command when the Policer
Enhancement—Multiple Actions feature has been configured. The following sample output from the
show policy-map command displays the configuration for a service policy called "police." In this
service policy, traffic policing has been configured to allow multiple actions for packets marked as
conforming to, exceeding, or violating the CIR or the PIR shown in the example.
Router# show policy-map police
Policy Map police
Class class-default
Packets conforming to the specified CIR (1000000 bps) are marked as conforming packets. These are
transmitted unaltered.
Packets exceeding the specified CIR (but not the specified PIR, 2000000 bps) are marked as exceeding
packets. For these packets, the IP Precedence level is set to 4, the discard eligibility (DE) bit is set to 1,
and the packet is transmitted.
Packets exceeding the specified PIR are marked as violating packets. For these packets, the IP
Precedence level is set to 2, the DE bit is set to 1, and the packet is transmitted.
Note Actions are specified by using the action argument of the police command. For more information about
the available actions, see the police command reference page.
Table 45
OL-23890-01
describes the significant fields shown in the display.
show policy-map Field Descriptions—Configured for Two-Rate Traffic Policing
Description
Indicates that the police command has been configured to enable traffic
policing. Also, displays the specified CIR, conform burst size (bc), peak
information rate (PIR), and peak burst (BE) size used for marking packets.
Displays the action to be taken on packets conforming to a specified rate.
Displays the action to be taken on packets exceeding a specified rate.
Displays the action to be taken on packets violating a specified rate.
police cir 1000000 bc 31250 pir 2000000 be 31250
conform-action transmit
exceed-action set-prec-transmit 4
exceed-action set-frde-transmit
violate-action set-prec-transmit 2
violate-action set-frde-transmit
describes the significant fields shown in the display.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show policy-map
569