Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Refer to the "Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling" chapter of the
Cisco 7600 Series Router Cisco IOS Software Configuration Guide for additional information on setting
the drop threshold value.
Examples
This example shows how to set the drop threshold:
Router(config-if)# switchport
Router(config-if)# l2protocol-tunnel drop-threshold 3000
Router(config-if)#
Related Commands
Command
l2protocol-tunnel
l2protocol-tunnel cos
l2protocol-tunnel
global drop-threshold
l2protocol-tunnel
shutdown-threshold
show
l2protocol-tunnel
switchport
OL-23890-01
Description
Enables the protocol tunneling on an interface and specifies the type of
protocol to be tunneled.
Specifies a CoS value globally on all ingress Layer-2 protocol tunneling
ports.
Enables rate limiting at the software level.
Specifies the maximum number of packets that can be processed for the
specified protocol on that interface in 1 second.
Displays the protocols that are tunneled on an interface or on all interfaces.
Modifies the switching characteristics of the Layer 2-switched interface.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
l2protocol-tunnel drop-threshold
203
Advertisement
Table of Contents
