Ptp Priority1 - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ptp priority1

Sets the preference level for a clock; slave devices use the priority1 value when selecting a master clock.
The priority1 value is considered above all other clock attributes. Use the following commands to set
the ptp priority1 value.
Syntax Description priorityvalue
Defaults
The default value is 128.
Command Modes
Interface configuration
Command History Release
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Examples The following example shows how to enable ptp priority1 value:
Router# config t
Router# interface Vlan10
Router(config-if)# ptp priority1 128
Router(config-if)# exit
Router(config)# exit
Related Commands Command
ptp priority2
OL-23890-01
ptp priority1 priorityvalue
no ptp priority1 priorityvalue
Valid values are from 0–255. The default value is 128.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Sets the PTP priority2 value.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp priority1
349