Dejitter-Buffer - Cisco MWR 2941 Command Reference Manual

dejitter-buffer

dejitter-buffer
To configure the size of the dejitter buffer, use the dejitter-buffer command in CEM configuration mode.
To restore the dejitter buffer to its default size, use the no form of this command.
Syntax Description
size
Defaults
The default dejitter-buffer size is 4 milliseconds.
Command Modes
CEM configuration
Command History Release
12.3(7)T
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Examples The following example shows how to specify the size of the dejitter buffer:
Router# config t
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# dejitter-buffer 10
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands Command
cem
cem class
class cem
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
98
dejitter-buffer size
no dejitter-buffer
Specifies the size of the dejitter buffer in milliseconds. The range is 4 to 500
ms; the default is 4 ms.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(19)MR2.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Enters circuit emulation configuration mode.
Applies the CEM interface parameters defined in the given CEM
class name to the circuit.
Configures CEM interface parameters in a class that's applied to
CEM interfaces together in global configuration mode.
OL-23890-01