Network-Clock-Select Hold-Timeout - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

network-clock-select hold-timeout

The network-clock-select hold-timeout command specifies how long the router waits before
reevaluating the network clock entry. To remove a network-clock-select hold-timeout configuration,
use the no form of this command.
Syntax Description timeout
infinite
Defaults The default setting is network-clock-select hold-timeout infinite.
Command Modes
Global configuration
Command History Release
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Examples
The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select hold-timeout 2000
Router(config)# exit
Related Commands Command
set network-clocks
force-reselect
OL-23890-01
network-clock-select hold-timeout {timeout | infinite}
no network-clock-select hold-timeout {timeout | infinite}
A value in seconds that specifies how long the router waits before
reevaluating the network clock entry. Valid values are a number from
0–86400.
Specifies an infinite holdover.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Forces the router to re-select the network clock.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock-select hold-timeout
283