Match Atm Clp - Cisco MWR 2941 Command Reference Manual

match atm clp

match atm clp
To enable packet matching on the basis of the ATM cell loss priority (CLP), use the match atm clp
command in class-map configuration mode. To disable packet matching on the basis of the ATM CLP,
use the no form of this command.
Syntax Description This command has no arguments or keywords.
Command Default
Packets are not matched on the basis of the ATM CLP.
Command Modes
Class-map configuration (config-cmap)
Command History Release
12.0(28)S
12.2(28)SB
12.2(33)SRB
12.2(33)SRC
12.4(15)T2
12.2(33)SB
Cisco IOS XE
Release 2.3
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines
This command is supported on policy maps that are attached to ATM main interfaces, ATM
subinterfaces, or ATM permanent virtual circuits (PVCs). However, policy maps (containing the match
atm clp command) that are attached to these types of ATM interfaces can be input policy maps only.
This command is supported on the PA-A3 adapter only.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
218
match atm clp
no match atm clp
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(28)SB.
This command was integrated into Cisco IOS Release 12.2(33)SRB.
Support for the Cisco 7600 series router was added.
This command was integrated into Cisco IOS Release 12.4(15)T2.
Support for the Cisco 7300 series router was added.
This command was integrated into Cisco IOS XE Release 2.3.
This command was integrated into Cisco IOS Release 12.4(20)MR. This
release uses the syntax match atm clp instead of match atm-clp.
This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release uses the syntax match atm clp instead of match atm-clp.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01