Ethernet Cfm Alarm - Cisco MWR 2941 Command Reference Manual

ethernet cfm alarm

ethernet cfm alarm
To configure an alarm for Ethernet connectivity fault management (CFM), use the ethernet cfm alarm
command in global configuration mode. To restore the command options' default values, use the no
form of this command.
Syntax Description
delay
mseconds
notification
all
error-xcon
mac-remote-error-xco
n
none
remote-error-xcon
xcon
reset
Command Default Ethernet CFM alarms are disabled.
Command Modes Global configuration (config)
Command History Release
12.2(33)SXI2
12.2(33)SRE
15.0(1)MR
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
110
ethernet cfm alarm {delay mseconds | notification {all | error-xcon | mac-remote-error-xcon |
none | remote-error-xcon | xcon} | reset mseconds}
no ethernet cfm alarm {delay | notification {all | error-xcon | mac-remote-error-xcon | none |
remote-error-xcon | xcon} | reset}
Sets a delay time value during which one or more defects must be present
before a fault alarm is issued.
Integer from 2500 to 10000 that specifies the number of milliseconds for
either a delay or a reset of an alarm.
•
Sets the defects that are to be reported if fault alarms are enabled. This
configuration is global and can be overridden by the fault alarm
configurations on a supported interface.
Reports all defects: DefRDI, DefMACStatus, DefRemote, DefError, and
DefXcon.
Reports only DefError and DefXcon defects.
Reports only DefMACStatus, DefRemote, DefError, and DefXcon (default)
defects. This option is the default.
No defects are reported.
Reports only DefRemote, DefError, and DefXcon defects.
Reports only DefXcon defects.
Sets a reset time value that, after a fault alarm, no defects must be present
before another fault alarm is enabled.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
The default is 2500 for the delay option. The default is 10000 for the
reset option.
OL-23890-01