Sender-Id (Cfm-Srv) - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

sender-id (CFM-srv)

To indicate the contents of the Sender ID TLV field transmitted in Ethernet connectivity fault
management (CFM) messages for the maintenance association, use the sender-id command in Ethernet
CFM service configuration mode. To send no sender ID information, use the no form of this command.
Syntax Description chassis
none
Command Default
The Sender ID TLV is not included in messages.
Command Modes
Ethernet CFM service configuration (config-ecfm-srv)
Command History Release
12.2(33)SXI2
12.2(33)SRE
15.0(1)MR
Usage Guidelines This command has higher precedence than the sender-id command issued for the maintenance domain.
The default is that the enclosing maintenance domain determines the Sender ID.
Examples The following example shows how to include only the chassis ID information in the Sender ID TLV:
Router(config)# ethernet cfm domain customerA level 5
Router(config-ecfm)# service vlan-id 17 port
Router(config-ecfm-srv)# sender-id chassis
OL-23890-01
sender-id {chassis | none}
no sender-id {chassis | none}
Sends only the chassis ID information.
No sender ID information is sent.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
sender-id (CFM-srv)
391