Cisco MWR 2941 Command Reference Manual page 666

spanning-tree portfast default
You can enable PortFast mode on individual interfaces using the spanning-tree portfast (interface)
command.
Examples This example shows how to enable PortFast by default on all access ports in releases earlier than
Cisco IOS Release 12.2(33)SXI:
Router(config)# spanning-tree portfast default
Router(config)#
This example shows how to enable PortFast edge mode with BPDU Guard by default on all access ports
in Cisco IOS Release 12.2(33)SXI and later releases:
Router(config)# spanning-tree portfast edge bpduguard default
Router(config)#
Related Commands Command
show spanning-tree
spanning-tree portfast
(interface)
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
648
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Displays information about the spanning-tree state.
Enables PortFast on a specific interface.
OL-23890-01