Cisco MWR 2941 Command Reference Manual page 598

show policy-map interface
Release
12.2(28)SB
12.2(31)SB2
12.2(33)SRC
12.4(15)T2
12.2(33)SB
Cisco IOS XE 2.1
12.4(20)T
12.2(33)SXI
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines The show policy-map interface command displays the packet statistics for classes on the specified
interface or the specified PVC only if a service policy has been attached to the interface or the PVC.
The counters displayed after the show policy-map interface command is entered are updated only if
congestion is present on the interface.
Examples This section provides sample output from typical show policy-map interface commands. Depending
upon the interface or platform in use and the options enabled, the output you see may vary slightly from
the ones shown below.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
580
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Modification
This command was integrated into Cisco IOS Release 12.2(28)SB, and the
following modifications were made:
• This command was modified to display either legacy (undistributed
processing) QoS or hierarchical queueing framework (HQF) parameters
on Frame Relay interfaces or PVCs.
This command was modified to display information about Layer 2
•
Tunnel Protocol Version 3 (L2TPv3) tunnel marking.
The following modifications were made:
This command was enhanced to display statistical information for each
•
level of priority service configured and information about
bandwidth-remaining ratios, and this command was implemented on the
Cisco 10000 series router for the PRE3.
• This command was modified to display statistics for matching packets
on the basis of VLAN identification numbers. As of Cisco IOS
Release 12.2(31)SB2, matching packets on the basis of VLAN
identification numbers is supported on Cisco 10000 series routers only.
This command was integrated into Cisco IOS Release 12.2(33)SRC.
This command was modified to display information about Generic Routing
Encapsulation (GRE) tunnel marking.
Note As of this release, GRE-tunnel marking is supported on the
Cisco MGX Route Processor Module (RPM-XF) platform only.
This command was modified to display information about GRE-tunnel
marking, and support for the Cisco 7300 series router was added.
This command was integrated into Cisco IOS XE Release 2.1 and was
implemented on the Cisco ASR 1000 series router.
Support was added for hierarchical queueing framework (HQF) using the
Modular Quality of Service (QoS) Command-Line Interface (CLI) (MQC).
This command was implemented on the Catalyst 6500 series switch and
modified to display the strict level in the priority feature and the counts per
level.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support Weighted Random Early Detection (WRED).
OL-23890-01