Controller - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

controller

To configure a T1, E1, or BITS controller and enter controller configuration mode, use the controller
command in global configuration mode.
Syntax Description bits
t1
e1
shdsl
slot/port
subslot
number
port
Defaults
No T1 or E1 controller is configured.
Command Modes
Global configuration
Command History Release
10.0
10.3
12.0(3)T
12.2(7)XO
12.2(33)SRA
12.4(19)MR2
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR
Usage Guidelines
This command is used in configurations where the router or access server is intended to communicate
with a T1 or E1 fractional data line. Additional parameters for the T1 or E1 line must be configured for
the controller before the T1 or E1 circuits can be configured by means of the interface global
configuration command.
To view the status of the controllers use the show controllers command.
Examples
The following example configures slot 0, port 2 of the router as an E1 controller:
OL-23890-01
controller {bits | t1 | e1 | shdsl} slot/port/subslot number/port number
BITS controller
T1 controller.
E1 controller.
SHDSL controller.
Backplane slot number and port number on the interface. Refer to your hardware
installation manual for the specific values and slot numbers.
Defines the subslot on the router in which the HWIC is installed.
Port number of the controller. Valid numbers are 0 and 1. The slash mark (/) is
required between the slot argument and the port argument.
Modification
This command was introduced.
The e1 keyword was added.
Support was added for dial shelves on Cisco AS5800 access servers.
The j1 keyword was added for the Cisco 2600 and Cisco 3600 series.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release12.4(19)MR2.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
controller
93