Cisco MWR 2941 Command Reference Manual page 706

xconnect
Release
12.3(2)T
12.2(25)S
12.2(27)SBC
12.4(11)T
12.2(33)SRB
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Usage Guidelines The combination of the peer-ip-address and vcid arguments must be unique on the router. Each xconnect
configuration must have a unique combination of peer IP address and VCID configuration.
The same vcid value that identifies the attachment circuit must be configured using the xconnect
command on the local and remote PE routers. The vcid argument creates the binding between a PW and
an attachment circuit.
The pw-class pw-class-name value binds the xconnect configuration of an attachment circuit to a
specific pseudowire-class. In this way, the pseudowire-class configuration serves as a template that
contains settings used by all attachment circuits bound to it with the xconnect command.
Note If you specify the encapsulation keywords, you must specify the pw-class keyword.
Examples
The following example configures xconnect service for an ATM interface by binding the ATM circuit
to the PW named 123 with a remote peer 10.0.3.201. The configuration settings in the pseudowire class
named ATM-xconnect are used.
Router# config tby
Router(config)# interface ATM 0/0
Router(config-if)# xconnect 10.0.3.201 123 pw-class ATM-xconnect
Router(config-if-xconn)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands Command
pseudowire-class
show xconnect
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
688
Modification
This command was integrated into Cisco IOS Release 12.3(2)T.
This command was integrated into Cisco IOS Release 12.2(25)S.
This command was integrated into Cisco IOS Release 12.2(27)SBC.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was updated to add support for AToM static pseudowires, and
so that the remote router ID need not be the Label Distribution Protocol (LDP)
router ID of the peer.
This command was integrated into Cisco IOS Release 12.4(19)MR2.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the ignore-vpi-vci or the one-to-one keywords.
Description
Configures a template of PW configuration settings used by the
attachment circuits transported over a PW.
Displays information about xconnect attachment circuits and PWs.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01