Match Precedence - Cisco MWR 2941 Command Reference Manual

match precedence

match precedence
To identify IP precedence values to use as the match criterion, use the match precedence command in
class-map configuration mode. To remove IP precedence values from a class map, use the no form of
this command.
Syntax Description
ip
precedence-criteria1
precedence-criteria2
precedence-criteria3
precedence-criteria4
Command Default No match criterion is configured.
If you do not enter the ip keyword, matching occurs on both IPv4 and IPv6 packets.
Command Modes
Class-map configuration mode (config-cmap)
Command History Release
12.2(13)T
12.0(17)SL
12.0(28)S
12.2(31)SB
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines You can enter up to four matching criteria, as number abbreviation (0 to 7) or criteria names (critical,
flash, and so on), in a single match statement. For example, if you wanted the precedence values of 0, 1,
2, or 3 (note that only one of the precedence values must be a successful match criterion, not all of the
specified precedence values), enter the match ip precedence 0 1 2 3 command. The precedence-criteria
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
228
match [ip] precedence {precedence-criteria1 | precedence-criteria2 | precedence-criteria3 |
precedence-criteria4}
no match [ip] precedence {precedence-criteria1 | precedence-criteria2 | precedence-criteria3 |
precedence-criteria4}
(Optional) Specifies that the match is for IPv4 packets only. If not used, the
match is on both IP and IPv6 packets.
Identifies the precedence value. You can enter up to four different values,
separated by a space. See the "Usage Guidelines" for valid values.
Modification
This command was introduced. This command replaces the match ip
precedence command.
This command was implemented on the Cisco 10000 series router.
Support for this command in IPv6 was added on the Cisco 12000 series
Internet router.
This command was integrated into Cisco IOS Release 12.2(31)SB.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01