Table of Contents
Advertisement
police rate (control-plane)
police rate (control-plane)
To configure traffic policing for traffic that is destined for the control plane, use the police rate
command in QoS policy-map class configuration mode. To remove traffic policing from the
configuration, use the no form of this command.
Syntax for Percent
Syntax Description
units
pps
burst burst-in-packets
packets
peak-rate peak-rate-in-pps
pps
peak-burst
peak-burst-in-packets
packets
bps
burst burst-in-bytes bytes
peak-rate peak-rate-in-bps
bps
peak-burst
peak-burst-in-bytes bytes
percent
percentage
burst ms ms
peak-rate percent
percentage
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
312
police rate units pps [burst burst-in-packets packets] [peak-rate peak-rate-in-pps pps]
[peak-burst peak-burst-in-packets packets] [conform-action action]
no police rate units pps [burst burst-in-packets packets] [peak-rate peak-rate-in-pps pps]
[peak-burst peak-burst-in-packets packets] [conform-action action]
police rate percent percentage [burst ms ms] [peak-rate percent percentage] [peak-burst ms ms]
no police rate percent percentage [burst ms ms] [peak-rate percent percentage] [peak-burst
ms ms]
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Specifies the police rate. If the police rate is specified in pps, the valid
range of values is 1 to 2000000 pps. If the police rate is specified in bps,
the valid range of values is 8000 to 20000000000.
Specifies that packets per seconds (pps) will be used to determine the
rate at which traffic is policed.
(Optional) Specifies the burst rate, in packets, will be used for policing
traffic. Valid range of values is 1 to 512000.
(Optional) Specifies the peak information rate (PIR) will be used for
policing traffic and calculating the PIR. Valid range of values is 1 to
512000.
(Optional) Specifies the peak burst value, in packets, will be used for
policing traffic. Valid range of values is 1 to 512000.
(Optional) Specifies that bits per second (bps) will be used to determine
the rate at which traffic is policed.
(Optional) Specifies the burst rate, in bytes, will be used for policing
traffic. Valid range is from 1000 to 512000000.
(Optional) Specifies the peak burst value, in bytes, for the peak rate.
Valid range is from 1000 to 512000000.
(Optional) Specifies the peak burst value, in bytes, will be used for
policing traffic. Valid range is from 1000 to 512000000.
A percentage of interface bandwidth will be used to determine the rate at
which traffic is policed.
Specifies the bandwidth percentage. Valid range is from 1 to 100.
(Optional) Specifies the burst rate, in milliseconds, will be used for
policing traffic. Valid range is from 1 to 2000.
(Optional) Specifies a percentage of interface bandwidth will be used to
determine the PIR. Valid range is from 1 to 100.
OL-23890-01
Advertisement
Table of Contents
