Requirements For Safe Use; Power Source - Konica Minolta 7165 Instruction Manual

Requirements for Safe Use

To ensure your safe use of the machine, the following describes the
precautions you are required to observe without fail for the power source of
the machine and during installation and routine handling. Be sure to read
and observe them.

Power Source

CAUTION: Plug Socket
• A plug socket is limited in capacity. Use only a power source with the
correct rating for the machine; otherwise, hazardous situations such as
smoking or overheating may occur. See the following list to match the
power supply and power consumption:
a) 230V/50Hz: More than 10A
b) 230V/60Hz: More than 10A
• Avoid multiple connections in the same outlet. Do not use multiple outlet
adaptors.
CAUTION: Power Plug and Lead
• Be sure to insert the power plug firmly into the power socket. Otherwise an
accident may occur as a result of smoking or overheating. If the inserted
power plug is loose in the socket, even after it has been positively inserted,
disconnect the plug and contact your electrical contractor.
• For plug cable equipment, that the socket-outlet shall be installed near the
equipment and shall be easily accessible.
• Do not bend or crush the power lead. If your copier power lead is bent or
damaged in any way, contact your service representative immediately. Do
not attempt to repair it yourself, and do not continue to operate the copier.
A damaged power lead may result in overheating, a short circuit, or fire.
• Do not bundle or coil the power lead of the copier. Otherwise an accident
may occur as a result of overheating or fire.
• When using the power cord (inlet type) that came with this copier, be sure
to observe the following precautions:
a. Make sure the copier-side power plug is securely inserted in the socket
on the rear panel of the copier.
Secure the cord with a fixture properly.
b. If the power cord or sheath is damaged, replace with a new power cord
(with plugs on both ends) specified by Konica.
If the power cord (inlet type) is not connected to the copier securely, a
contact problem may lead to increased resistance, overheating, and risk
of fire.
1
Safety
Information
1-5