Loading Tabbed Sheets In Multi-Sheet Bypass Tray - Konica Minolta 7165 Instruction Manual

7155e02v1.fm 28 ページ ２００１年１１月２８日 水曜日 午前１０時３１分

Loading Tabbed Sheets in Multi-Sheet Bypass Tray

Front
Front
1.
Open the Multi-sheet bypass tray located on the right side of the
copier.
2.
Load tabbed sheets as illustrated above.
3.
Adjust the paper guides to the paper size.
4.
Specify the paper type as TAB for the Multi-sheet bypass tray.
2-28
Example: 3 Tabbed sheets loaded in position for one finished set.
Rear
Printed
side
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Rear
Section 1
Introduction
Introduction
Printed
side
Please Be Reminded!
The tab extension width should be 12.5mm or less.
HINT
See p. 3-29 to p. 3-32 for specifying the paper type of the Multi-sheet
bypass tray.
Loading Paper (continued)
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
ONE FINISHED SET
1st TAB
1st TABS
Section 1
Introduction
Section 1
2nd TABS
Section 1
Introduction
3rd TABS
3 FINISHED SETS
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
2nd TAB
Section 1 Section 1
Introduction Introduction
3rd TAB