Using Finisher - Konica Minolta 7165 Instruction Manual

Programmed Shut-Off (Weekly Timer) (continued)
The Timer Interrupt password is not factory set and must be entered by the
Key Operator.
In the event the Timer Interrupt password has not been entered by the Key
Operator, the following message will display instead.
Input copy time
0 hour(s)
When the above message displays, proceed to step 4.
2.
Enter the password.
Enter a 4-digit number Timer Interrupt password using the keypad on the
control panel.
For setting the Timer Interrupt password, see p. 13-35.
If an invalid password is entered, continue by entering the valid 4-digit
password.
3.
Press [START].
The following message will be displayed on the Basic Screen.
Input copy time
0 hour(s)
4.
Set the hour for the interrupt use.
Enter a 1-digit hour (ex. 3 hours is 3) using the keypad on the control panel.
(0 ~ 9)
5.
Press [START].
6.
Set the minute for the interrupt use.
Enter a 2-digit minute (ex. 7 minutes is 07) using the keypad on the control
panel. (00 ~ 59)
Entering a number smaller than 5 will set the minute at 5.
7.
Press [START].
Copying is available until the set time is up.
05 minute(s)
HINT
FOR DETAILS
05 minute(s)
FOR DETAILS
Weekly
Timer
Rotation
Vertical/Hori-
zontal Zoom
Fold /
Stitch&Fold
Punch
Three-Fold
Cover Sheet
Feeding

Using Finisher

Manually
Tandem Mode
7
A dvanced
Information
7-3