Copier Initial Setting; C Opier Initial Setting - Konica Minolta 7165 Instruction Manual

7155e131v1.fm 10 ページ ２００１年１１月２７日 火曜日 午後４時５４分

[2] Copier Initial Setting

Initial settings are the settings that display automatically when the copier is
powered on, when Auto/Reset timer is operated, or when [ AUTO RESET ]
key is pressed. These settings can be changed by the Key Operator, as
shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition
to meet Energy Star requirements:
Initial Setting
Copy Mode
Copy Density : AE
Lens Mode
Paper Tray
Output Mode : offset sort
When Initial settings are changed by the Key Operator, the new initial
settings display when the copier is powered on, when Auto/Reset timer is
reached, or when [ AUTO RESET ] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode
Copy density
Lens mode
Paper tray
Output mode
Special original : [Original Direction; Text/Photo Enhance; Special
Rotation
Setting procedures are described on the following pages.
13-10
: 1-1
: 1:1
: APS
: [RADF; 1-1; 1-2; 2-2; 2-1]
: [AE; manual]
: [AMS; ratio 0.25~4.00]
: [APS; trays 1, 2, 3, or LCT]
: [Non-sort; Sort, Group; Staple-sort; Stitch&Fold;
Fold; Punch; Three-fold; Cover sheet]
Original; Original Form]
: OFF
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the
overall and long-range effect of the change.