Konica Minolta 7165 Instruction Manual page 92

7155e032v1.fm 34 ページ ２００１年１１月２８日 水曜日 午前１１時１２分
4.
Position original(s).
Using platen glass:
Place original FACE DOWN. Start scanning from the first page.
Using RADF:
Position originals FACE UP.
If the number of originals exceeds 100, divide them into blocks not exceeding
100 sheets and load them from the block with the first page.
5.
Press [ START ] to scan.
6.
Touch STORE to exit the Store mode.
STORE will return to the normal display.
7.
Press [ START ].
All the data in memory will be output.
Press [ STOP ] to suspend the printing job.
3-34
Copying Using Memory (continued)
Please Be Reminded!
When Dual Page, Non-Image Area Erase, Auto detection mode of
Repeat, or AUTO Layout is selected, keep the RADF open throughout
the scanning procedure.
HINT
See p. 3-2 to p. 3-5 for details on positioning originals.
FOR DETAILS
Repeat steps 4 and 5 until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to
check the remaining memory.
To delete the scanned data without printing, press [ STOP ], then touch
EXIT on the confirmation screen to be sure the data is deleted.
HINT
Should memory overflow occur frequently, it is recommended that you
contact your Konica service representative to extend the memory
capacity in your machine.
CAUTION
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.