Punching File Holes In Copies (Punch); P Unching File Holes In Copies (Punch) - Konica Minolta 7165 Instruction Manual

7155e07v1.fm 12 ページ ２００１年１１月２８日 水曜日 午後５時３３分

Punching File Holes in Copies (Punch)

The Punch mode is available only when the PK-110 Punching kit option is
installed on the FS-110/FS-210 Finisher.
When the Punch mode is selected in combination with any of the Primary
(Main) tray output modes, each copied sheet is punched and output to the
Primary tray according to the selected output mode.
>>>Specifications for Punch Mode<<<
❒ Copy paper size: A3, B4, F4, A4, B5 (80g/m
❒ Paper weight: 60 ~ 90g/m
Thin paper: 50 ~ 59g/m
Thick paper: 91 ~ 170*g/m
*Some 170g/m
❒ Number of holes: 4 holes
❒ Hole diameter: 6.5 mm ± 0.5 mm
❒ Hole pitch: 80 mm ± 0.5 mm
❒ Incompatible Conditions: Using platen glass (available when using Platen
store mode), Fold, Stitch & Fold, Three-Fold, Output to Secondary (sub)
tray, Cover sheet feeding, Mixed Original (A4R, B5R, A5, A5R mixed and/or
selecting APS mode), Non STD Size, Sheet/Cover Insertion, Copy Insertion
mode in Chapter, Cover Sheet mode in Booklet, OHP Interleave, Program
Job
7-12
FOR DETAILS
• Some staple positions previously selected may conflict with this
function.
• Special size paper (STD size (special), Non STD size, Wide size)
cannot be punched.
• If the ATS (Automatic Tray Switching) functions while the machine
uses the Punch mode, the punch holes may be slightly off the appro-
priate positions.
Please Be Reminded!
• Do not punch special paper type such as transparent films, labels,
tabbed sheets, etc. Otherwise, machine trouble may occur in Punching
kit.
• Be sure that the side guide plates of the paper tray are securely
aligned to the paper; otherwise the copies may not be punched in
position.
2
2
2
2
paper types may not be punched easily.
80mm
2
paper recommended)