Konica Minolta 7165 Instruction Manual page 226

7155e092v1.fm 38 ページ ２００１年１１月２７日 火曜日 午後４時１５分
Repeating Automatically or Selecting Repeating Times
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
6.
Select the desired magnification and paper size.
7.
Enter the desired print quantity from the control panel keypad.
8.
Position original.
For AUTO mode original, open the document feeder, then position the
original FACE DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
9.
Press [ START ].
9-38
(Repeat: AUTO/ Repeat Mode) (continued)
FOR DETAILS
• APS and AMS are automatically released, and 1.00 (100%) is
selected as a magnification ratio.
• When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area
will be a portion of the selected paper size equally divided according
to the selected mode.
In this case, magnification ratio will be fixed to 1.00 (100%).
• Copy mode is automatically set to 1 s 1. When selecting 1 s 2 mode,
Platen store mode will function automatically.
HINT
See p. 3-6 for details on setting print quantity.
HINT
See the illustration on p. 9-36 for details.
Please Be Reminded!
When AUTO mode is selected, Non-Image Area Erase functions
automatically.
DO NOT close the document feeder.
CAUTION
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
FOR DETAILS
The AUTO mode may not operate properly if the lighting in the work
place is directly over the platen glass. In this case, consult your service
representative about an appropriate place for installation.