Requirements For Safe Use; Power Source - Konica Minolta 8050 Instruction Manual

Requirements for Safe Use

To ensure your safe use of the machine, the following describes the precautions you
are required to observe without fail for the power source of the machine and during
installation and routine handling. Be sure to read and observe them.

Power Source

CAUTION: Plug Socket
• A plug socket is limited in capacity. Use only a power source with the correct rating
for the machine; otherwise, hazardous situations such as smoking or overheating
may occur.
• Avoid multiple connections in the same outlet. Do not use multiple outlet adaptors.
CAUTION: Power Plug and Cord
• Be sure to insert the power plug firmly into the power socket. Otherwise an
accident may occur as a result of smoking or overheating. If the inserted power
plug is loose in the socket, even after it has been positively inserted, disconnect
the plug and contact your electrical contractor.
• For plug cable equipment, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
• Do not bend or crush the power cord. If your copier power cord is bent or damaged
in any way, contact your service representative immediately. Do not attempt to
repair it yourself, and do not continue to operate the copier. A damaged power
cord may result in overheating, a short circuit, or fire.
• Do not bundle or coil the power cord of the copier. Otherwise an accident may
occur as a result of overheating or fire.
CAUTION: Connecting Multiple Loads to One Socket Outlet Prohibited
Never connect multiple loads to one socket outlet using a multi-outlet extension cord
or branched socket. Otherwise an accident may occur as a result of overheating or
fire.
CAUTION: Extension Cord
An extension cord must never be used with this machine.
1-6