Entering An Ekc Password (Ekc) - Konica Minolta 7165 Instruction Manual

7155e02v1.fm 18 ページ ２００１年１１月２８日 水曜日 午前１０時３１分
Turning On the Main Power Switch and Power Switch (continued)

Entering an EKC Password (EKC)

The Electronic Key Counter (EKC) allows the Key Operator to monitor all
copying activities by controlling EKC password accounts. Copy quantity
limits for specific accounts can be set.
The EKC is not factory-set. An EKC password is required only when the
EKC is activated; a User Password is assigned; and "Enter E.K.C.
password" is displayed on the touch screen.
Copying will be available by following procedure.
1.
Enter EKC password.
Enter your 8-digit EKC password, using the keypad.
2.
Press [ START ].
Your current copy count and copy limit will be displayed for 3 sec.
Current count / limit
018888/025000
3.
Start a copying job.
When the message changes to "Ready to copy", copying job is available on
the machine.
4.
Press [ C ] while pressing [ P ].
The initial state will be restored, with the message "Enter E.K.C. password"
displayed on the screen.
2-18
HINT
For details of the EKC setting, see p. 13-15 to p. 13-21.
HINT
For setting an EKC password, see p. 13-17 to p. 13-19.
FOR DETAILS
If an invalid EKC password is entered, continue by entering the correct
password.
FOR DETAILS
When your copy count reaches the copy limit, the message "Copy limit
reached" will be displayed. In that case, contact the Key Operator to
reset your copy limit.