Requirements For Safe Use; Power Source - Konica Minolta 7055 Instruction Manual

Requirements for Safe Use

To ensure your safe use of the machine, the following describes the precautions you are
required to observe without fail for the power source of the machine and during installation
and routine handling. Be sure to read and observe them.

Power Source

CAUTION: Plug Socket
• A plug socket is limited in capacity. Use only a power source with the correct rating for
the machine; otherwise, hazardous situations such as smoking or igniting may occur.
See the following list to match the power supply and power consumption:
a) 230V/50Hz: More than 10A
b) 110V/60Hz: More than 15A
c) 230V/60Hz: More than 10A
d) 127V/60Hz: More than 15A
• Avoid multiple connections in the same outlet. Do not use multiple outlet adaptors.
CAUTION: Power Plug and Lead
• Be sure to insert the power plug firmly into the power socket. Otherwise an accident
may occur as a result of smoking or igniting. If the inserted power plug is loose in the
socket, even after it has been positively inserted, disconnect the plug and contact your
electrical contractor.
• For plug cable equipment, that the socket-outlet shall be installed near the equipment
and shall be easily accessible.
• Do not bend or crush the power lead. If your copier power lead is bent or damaged in
any way, contact your Service Centre immediately. Do not attempt to repair it yourself,
and do not continue to operate the copier. A damaged power lead may result in
overheating, a short circuit, or fire.
• Do not bundle or coil the power lead of the copier. Otherwise an accident may occur
as a result of overheating or fire.
CAUTION: Connecting Multiple Loads to One Socket Outlet Prohibited
Never connect multiple loads to one socket outlet using a multi-outlet extension lead or
branched socket. Otherwise an accident may occur as a result of overheating or fire.
CAUTION: Extension Lead
An extension lead is limited in capacity. Unless the lead has adequate capacity, smoking
and/or igniting may occur, and an accident may be caused from overheating. Should
smoking and/or igniting occur, contact your electrical contractor immediately. If you require
further information about power requirements, power consumption, extension leads,
adapters and connectors, please contact your Konica service centre, and also consult
your electrical contractor.
When using an extension lead with a reel, let out the full length from the reel. Using the
lead in rolled-up condition may result in overheating, smoking and/or igniting.
Section 2 : Safety Information
2
Safety
Information
2 - 5