Requirements For Safe Use; Power Source - Konica Minolta 7020 Instruction Manual

Requirements for Safe Use

To ensure your safe use of the machine, the following describes the precautions you
are required to observe without fail for the power source of the machine and during
installation and routine handling. Be sure to read and observe them.
I Power Source
CAUTION: PLUG SOCKET
• A plug socket is limited in capacity. Use only a power source with the correct rating
for the machine; otherwise, hazardous situations such as smoking or overheating
may occur. See the following list to match the power supply and power consump-
tion:
a) 230V/50Hz: More than 10A
b) 110V/60Hz: More than 15A
c) 230V/60Hz: More than 10A
d) 127V/60Hz: More than 15A
• Avoid multiple connections in the same outlet. Do not use multiple outlet adaptors.
CAUTION: POWER PLUG AND LEAD
• Be sure to insert the power plug firmly into the power socket. Otherwise an acci-
dent may occur as a result of smoking or overheating. If the inserted power plug is
loose in the socket, even after it has been positively inserted, disconnect the plug
and contact your electrical contractor.
• For plug cable equipment, that the socket-outlet shall be installed near the equip-
ment and shall be easily accessible.
• Do not bend or crush the power lead. If your copier power lead is bent or damaged
in any way, contact your service centre immediately. Do not attempt to repair it
yourself, and do not continue to operate the copier. A damaged power lead may
result in overheating, a short circuit, or fire.
• Do not bundle or coil the power lead of the copier. Otherwise an accident may
occur as a result of overheating or fire.
CAUTION: CONNECTING MULTIPLE LOADS TO ONE SOCKET OUTLET
PROHIBITED
Never connect multiple loads to one socket outlet using a multi-outlet extension lead
or branched socket. Otherwise an accident may occur as a result of overheating or
fire.
CAUTION: EXTENSION LEAD
An extension lead must never be used with this machine.
1-4