Konica Minolta 7165 Instruction Manual page 209

Inserting Images into Printed Sets (Image Insert) (continued)
9.
Scan the platen glass images.
Open the document feeder.
Position an original FACE DOWN on the platen glass, then close the
document feeder.
PLACE AND SCAN THE ORIGINALS ACCORDING TO PAGINATION.
10.
Press [ START ].
11.
Repeat steps 9 and 10 for all originals.
• Memory overflow may occur during scanning. See p. 5-11 to p. 5-12.
• Should memory overflow occur frequently, it is recommended that you
contact your service representative to extend the memory capacity in
your machine.
12.
Touch STORE to exit the Store mode.
13.
Press [ START ].
The copier will start printing when ready for output.
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
For example, if insertion locations are [2/2/6], scanned platen images
will be inserted as follows:
The first scanned platen image will be inserted after page 2.
The second scanned platen image will be inserted directly after the first
scanned Image insertion.
The third scanned platen image will be inserted after page 6.
NOTES:
• When a page number is larger than the total original count, a sheet is
inserted as the last page.
• Insertions occur in sequence, even if page numbers are entered out
of sequence.
• Entering the same page number twice will insert two sheets at that
location.
Please Be Reminded!
HINTS
CAUTION
FOR DETAILS: Entering Page Numbers
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
OHP
Interleave
Image Insert
Dual Page
Program Job
Non-Image
Area Erase
Reverse
Image
9
Applications
Repeat
Frame/Fold
Erasure
AUTO
Layout
Full-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
9-21