Konica Minolta 7165 Instruction Manual page 81

Making Double-Sided Copy (1s s s s 2, 2s s s s 2) (continued)
4.
Select additional copy conditions, as desired.
Some incompatible conditions may automatically release the selected
copy mode. In this case, arrange all the settings to be compatible with
the selected copy mode.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-6 for details on setting print quantity.
6.
Position originals FACE UP in the document feeder according to
the original direction specified in step 2.
• See p. 3-2 to p. 3-4 for details on positioning originals.
• Use RADF store mode (p. 3-33 to p. 3-34) when the original count
exceeds 100.
7.
Press [START].
The machine starts to scan originals, then to print duplex copies when ready
for output.
Press [STOP] to suspend the scanning or printing job.
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
FOR DETAILS
HINT
HINTS
CAUTION
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1s1, 2s2
2s1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-110/210
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-23