Konica Minolta 7165 Instruction Manual page 216

7155e092v1.fm 28 ページ ２００１年１１月２７日 火曜日 午後４時１５分
Programming Different Settings for an Output Job (Program Job) (continued)
8.
Repeat steps 4 to 7 until all JOB originals are scanned.
9.
Select the desired output mode and enter the print quantity from
the control panel keypad.
10.
Touch STORE to exit the Store mode.
11.
Press [ START ].
9-28
Please Be Reminded!
PLACE AND SCAN EACH ORIGINAL SET IN THE CORRECT ORDER
OF PAGINATION.
HINTS
• Memory overflow may occur during scanning. See p. 5-11 to p. 5-12.
• Should memory overflow occur frequently, it is recommended that you
contact your service representative to extend the memory capacity in
your machine.
HINT
See p. 3-6 for details on setting print quantity.
CAUTION
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.