Interrupt Copying; I Nterrupt Copying - Konica Minolta 7165 Instruction Manual

Interrupt Copying

Use the Interrupt mode to interrupt copying in progress to perform a simple
job. When interrupt copying is completed, the settings for the initial job
restore automatically and the Basic Screen displays.
Interrupt copying is available when the copier is performing the following
operations:
• Continuously printing the image stored in memory
• Scanning the originals into memory
• Scanning the originals into memory while printing in Reserve mode
If desired, Key Operator can change the timing to stop current machine
operation for interrupt copying.
Note that the compatible copying conditions vary according to the timing
selected. See p. 13-39 to p. 13-45.
>>>
Specification for Interrupt Mode<<<
❒ The Interrupt mode cannot be selected with the following copier conditions:
The Basic Screen is not displayed.
Overlay Memory is in use.
The Call for Service message displays or a paper misfeed occurs.
❒ Incompatible: Reserve, Storing image in Overlay Memory
1.
Press [ INTERRUPT ] on the control panel.
The [ INTERRUPT ] LED turns on and all JOB indicators on the Basic Screen
change to INTERRUPT .
The timing to enter the Interrupt mode varies according to the job in
progress on the machine when [ INTERRUPT ] is pressed.
See the following page.
In Reserve mode, pressing [ INTERRUPT ] before the copier finishes
scanning the reserve job originals clears the settings selected for the
reserve job.
For details of Reserve mode, see p. 3-35 to p. 3-36.
HINT
HINT
FOR DETAILS
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1s1, 2s2
2s1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-110/210
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-55