Requirements For Safe Use; Power Source - Konica Minolta 7022 Instruction Manual

Requirements for Safe Use

To ensure your safe use of the machine, you are required to observe the following
precautions without fail for the machine's power source and during installation and
routine handling. Be sure to read and observe them.

Power Source

CAUTION: Plug Socket
• A socket is limited in capacity. Use only a power source with the correct rating for the
machine; otherwise, hazardous situations such as smoking or overheating may occur.
See the following list to match the power supply and power consumption:
a) 230V / 50Hz: More than 15A
b) 230V / 60Hz: More than 15A
• Avoid multiple connections in the same outlet. Do not use multiple outlet adaptors.
CAUTION: Power Plug and Cord
• Be sure to insert the power plug firmly into the power socket. Otherwise an accident
may occur as a result of smoking or overheating. If the inserted power plug is loose in
the socket, even after it has been positively inserted, disconnect the plug and contact
your electrical contractor.
• For plug cable equipment, the outlet must be near the equipment and easily
accessible.
• Do not bend or crush the power cord. If your copier power cord is bent or damaged in
any way, contact your service representative immediately. Do not attempt to repair it
yourself, and do not continue to operate the copier. A damaged power cord may result
in overheating, short circuit, or fire.
• Do not bundle or coil the power cord of the copier. Otherwise an accident may occur
as a result of overheating or fire.
CAUTION: Connecting Multiple Loads to One Outlet Prohibited
Never connect multiple loads to one outlet using a multi-outlet extension cord or branched
socket. Otherwise an accident may occur as a result of overheating or fire.
CAUTION: Extension Cord
An extension cord must never be used with this machine.
1-4