To Specify Desired Paper Size (Ams) - Konica Minolta 7165 Instruction Manual

7155e031v1.fm 12 ページ ２００１年１１月２８日 水曜日 午前１０時５２分

To Specify Desired Paper Size (AMS)

When a paper size is specified on the touch screen, an appropriate reduc-
tion or enlargement ratio will be selected automatically according to the
original size detected from the RADF or the platen glass.
1.
Touch a tray key on the Basic Screen to select the desired paper
size.
Selected tray key will be highlighted, and under the LENS MODE AMS indi-
cation will also be highlighted.
2.
Select additional copy conditions, as desired.
3.
Enter the desired print quantity from the control panel keypad.
4.
Position original(s).
5.
Press [ START ].
Scanned image will be printed on the specified paper size in the magnification
ratio automatically selected.
3-12
Selecting Paper Size (continued)
HINTS
• See the table on the following page for the relation of original size,
copy paper size, and magnification ratio automatically selected.
• Wide paper size can be specified when AMS is in use.
In this case, the same magnification ratio as that of the standard size
will be selected automatically.
• If copying in 1.00 (100%) magnification mode with specifying a paper
size is desired, see p. 3-11.
HINT
See p. 3-6 for details on setting print quantity.
HINTS
• See p. 11-7 to p. 11-9 for paper sizes detectable from the RADF or on
the platen glass.
• See p. 3-2 to p. 3-5 for details on positioning originals.