Konica Minolta 7165 Instruction Manual page 231

Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic
Screen.
• APS and AMS are automatically released, and 1.00 (100%) is
selected as a magnification ratio.
• Copy mode is automatically set to 1s1. When selecting 1s2 mode,
Platen store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-6 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
For details on positioning originals, see p. 3-2 to p. 3-5.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy
marks.
7.
Press [START].
When the finisher / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting in the
work place is directly over the platen glass. In this case, consult your
service representative about an appropriate place for installation.
FOR DETAILS
HINT
HINT
Please Be Reminded!
CAUTION
Having Any Problem?
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
OHP
Interleave
Image Insert
Dual Page
Program Job
Non-Image
Area Erase
Reverse
Image
9
Applications
Repeat
Frame/Fold
Erasure
AUTO
Layout
Full-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
9-43