NEC Xen IPK Features & Specifications Manual page 77

Xen IPK
SERVICE
CONDITIONS
Features and Specifications Manual
To answer by Two Levels:
1. Receive an incoming CO/PBX call.
2. The Automatic Answer with Delay Message answers the call and
sends a greeting.
3. The outside
Programmable).
4. After the time expires, a second message is played.
5. The outside party hears ringback tone or MOH until the call is
answered.
Data Assignment
A maximum of eight VRS(4)-U( ) ETU channels, four channels per
VRS(4)-U( ) ETU, can be used for Automated Attendant.
Each channel has 240 recording seconds that can be subdivided into
2, 4, 8 or 16 equal recording times.
A maximum of eight Automated Attendants can be assigned.
Automated Attendant can be assigned per CO/PBX line. Attendant
Positions can set or cancel the Automated Attendant per trunk.
The Day/Night Weekend mode greeting messages can be assigned to
each Automated Attendant position. The number of times a greeting
message is repeated can be assigned in System Programming.
The answering time (duration after the incoming CO/PBX call rings) is
programmable. This time affects the Day/Night/Weekend mode
settings per Automated Attendant.
The station can be used for recording, confirming, or deleting an
Automated Attendant message if it is allowed by Station Class of
Service assignment in System Programming.
Restrictions
Tie/DID lines are not supported by the Automatic Answer with Delay
Message feature.
DTMF digits cannot be dialled by the outside caller while in the
Automatic Answer with Delay Message mode.
CPUI( )-U( ) ETU Unit PBR circuits are not used for this feature.
Automatic Answer with Delay Message or Automated Attendant is
assigned per trunk.
Automatic Trunk-to-Trunk Transfer and the Automated Attendant
features cannot be set for the same trunk at the same time.
party hears ringback
Features and Specifications Manual
tone or MOH (System
A17 – 67