NEC Xen IPK Features & Specifications Manual page 539

Xen IPK
RELATED
FEATURES LIST
GUIDE TO
FEATURE
PROGRAMMING
Order
and
Shortcut
¶
Speed Dial Buffer Allocation
+BE
¶
Speed Dial Number/Name Display Selection
+BE
¶
System Speed Dial Restriction by Tenant
+AC
Features and Specifications Manual
A pause, hookflash,
Speed Dial buffer. Each item is counted as a digit, except the Trunk
and Trunk Group Access Code.
The built-in battery backup on the CPUI( )-U( ) ETU retains System
Speed Dial memories if power fails.
To verify System Speed Dial buffer contents, press the Conference
key, then the Redial key, and then dial the System Speed Dial buffer
(use 00~79 or 000~999) on a Multiline Terminal with an LCD display.
Multiline Terminal users may access two or more System Speed Dial
buffers by using the Consecutive Speed Dial feature.
A pause is automatically inserted if a PBX Access Code with a pause
is entered into a System Speed Dial buffer. (Must be allowed in
System Programming.)
Pauses should not be stored in Speed Dial in systems with the Least
Cost Routing (LCR) feature. These pauses may cause the MIFM-U( )
ETU with KMM( )UA to seize a Least Cost Route because the pauses
may be considered digits dialled. In systems using the LCR feature,
pauses should be programmed as part of extra codes in the Extra
Code Add Table.
Feature
Number
C-23 Consecutive Speed Dial
F-1 Feature Access – User Programmable
N-1 Nesting Dial
S-10 Speed Dial – Station
System Data Name
Features and Specifications Manual
, and # may be programmed into a System
Feature Name
Memory
Function
Block
1-1-35
1-1-33
1-1-18
1-8-07 1-8-08
Attendant Station
Page-Line Page-Line
Key Key
S12 – 531