NEC Xen IPK Features & Specifications Manual page 474

July 2003
SERVICE
CONDITIONS
466 – P8
To activate Privacy Release from a Multiline Terminal with a CO/PBX
call in progress:
1. Lift the handset or press
2. Press the CO/PBX Line key or CAP key that released privacy.
To Enter a Conversation using the Privacy Release from a Multiline
Terminal:
1. Press the flashing line key or dial trunk access code for the trunk.
Data Assignment
Use Memory Block 2-05 (Line Key Selection) to assign Tenant-Wide or
Telephone (default) Mode for each Tenant.
Use Memory Block 2-06 (Line Key Selection for Tenant Mode) to
assign CO/PBX trunks to the applicable Tenant
Use Memory Block 4-12 (Line Key Selection for Telephone Mode) to
assign Feature Access Key (Page 1 LK6).
Restrictions
Privacy Release is only available on an Outside line.
Only two additional stations can be added per CO/PBX call after
Privacy Release. After two parties have joined the conversation, the
Conf key LED at all stations that did not enter is turned off. A third
station that tries to enter receives a busy signal.
If the originating caller abandons the call, the user cannot enter the
call again.
If there internal stations are connected to the CO/PBX, Privacy
Release cannot be activated again until both added stations release
the CO/PBX line.
A maximum of 16 Privacy Release calls are available.
Voice Over is
Privacy Release.
When a station is receiving Voice Over, activating Privacy Release is
ignored and Voice Over continues.
Privacy Release and Live Record are not allowed at the same time.
Privacy Release cannot be used on Single Line Telephones.
Setting one feature will automatically cancel the other.
Specified CO/PBX
Privacy Release.
P
.
prohibited to a station
seizure cannot
NEC Business Solutions Ltd
that has activated
be used to activate
Privacy Release