Automatic Carrier Routing - NEC Xen IPK Features & Specifications Manual

Automatic Carrier Routing

FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
Automatic Carrier Routing (ACR) allows an outgoing line to be seized using
a Trunk Group or Route Advance Block (RAB) for each number
dialled by the user. The ACR feature allows better use of the trunks
connected to the system.
Terminal Type:
All terminals.
Required Components:
None.
To use this feature:
1. Lift the handset, and wait for dial tone.
2. Dial ACR access code 0 (default) and receive LCR dial tone.
3. Dial the desired number.
Data Assignments
Use Memory Block 1-1-46~48 [Access Code (1-, 2- or 3-Digit)
Assignment] (Function No.101) to assign an access code.
Use Memory Block 3-03 (Trunk-to-Trunk Group Assignment) to make
Trunk-to-Trunk Group Assignment.
Use Memory Block 4-40 (LCR Class Selection) to specify the LCR
Class (default: 0) for each station.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 6 LK1 to program Trunk Groups 2~32 to Allow (LED
On) or Deny (default: LED Off) ACR Bypass.
Restrictions
Route Advance Blocks or Trunks programmed on a line key,
bypass ACR.
ACR is not available when the Xen IPK system is in KF registration.
Outgoing calls using Direct Inward System Access (DISA) cannot
access ACR.
ACR cannot be used to route calls by hour of day or day of week.
A-22
A22 – 95