NEC Xen IPK Features & Specifications Manual page 26

July 2003
SERVICE
CONDITIONS
16 – A2
Data Assignment
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2], Page 6 LK3 to Allow (LED On) or Deny (default: LED Off)
Forced Account Code Unverified.
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] to assign the Forced Account Code Access (Function
No. 147).
Use Memory Block 1-8-27 (Forced Account Code Length Assignment)
to assign the number of digits for Account Codes system-wide. One to
13 digits can be assigned; default is 10 digits.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
necessary MIFM-U( ) ETU.
Restrictions
Existing Code restrictions, Automatic Carrier Routing (ACR) and Least
Cost Routing (LCR) assignments are applied after Forced Account
Codes are entered.
Emergency 000 (111 NZ) calls cannot be made unless a valid Forced
Account Code is entered.
A one-touch key must be programmed on these handsets allowing
emergency number access.
Verified and Unverified Forced Account Codes cannot be used in the
same Class of Service.
General
Only outgoing calls from Intercom require a Forced Account Code.
Direct access to trunks bypasses this feature, that is, by pressing a line
key, or dialling trunk access code.
The Forced Account Code without verification feature allows the user
to place an outgoing call without Account Code verification only the
length is verified.
Reorder tone is provided if an outgoing call is dialled without entering
the Forced Account Code access code and a valid Forced
Account Code.
Call Alert Notification is not provided during Account Code Entry.
PBR Timer values apply when using a Single Line Telephone to enter
a Forced/Unverified Account Code.
Verified and Unverified Forced Account Codes will be printed on the
SMDR report if both features are used.
An 'A' is placed in front of the Forced/Unverified Account Codes on the
SMDR reports to distinguish them from other Account Code entries.
The Interdigit Timer (10sec) is applicable when a user inputs an
Account Code. Busy Tone is received if the timer expires.
NEC Business Solutions Ltd
Account Code - Forced/Unverified