NEC Xen IPK Features & Specifications Manual page 194

July 2003
SERVICE
CONDITIONS
184 – C13
To retrieve a parked call from either a Multiline Terminal or a Single
Line Telephone:
1. Go off-hook, and receive internal dial tone.
2. Dial the Call Park Retrieve Access Code
3. Dial the Call Park location number (
retrieved.
4. Talk with party.
Data Assignment
A recall timer for a parked call can be programmed in System
Programming (default: 1 minute).
General
Any call left in Call Park for more than the programmed time recalls to
the station where the call was originally parked. The Call Park location
becomes idle after the recall, and the trunk line key switches to
Non-Exclusive Hold.
When attempting to set Call Park to a busy Call Park location, and a
busy tone is heard, Step Call can be used to access an idle location to
park the call.
If a station other than the station originally used to park the call
retrieves the call, the SMDR records a transfer to the station where the
call is retrieved.
When a Call Park is in recall mode, the call cannot be picked up using
the Call Park retrieval Access Code.
Call Park is set and retrieved from internal dial tone.
Outside calls and internal calls can be parked from any station.
Conference calls cannot be parked.
When attempting to set Call Park while all Call Park locations are busy,
a busy tone is heard and ALL PARK BUSY is displayed on Multiline
Terminals with LCDs.
NEC Business Solutions Ltd
(set as default).
DL
~ ) of the call to be
0 I
Call Park - System