Load The Media - Oce VarioPrint 4110 User Manual

Load the media

Load the media
Introduction
This section describes how to load the media into a paper tray.
When you load the media via the 'Load' button in the 'Schedule', the paper tray is auto-
matically assigned to the correct media.
When you load and assign the media via the 'Assign' button in the 'Trays' view, you must
assign the paper tray to the loaded media manually.
When no external finisher is connected to the machine, you must put all the media types
face down and header down into the paper trays. Cyclic media is straight collated. The
tabs of tab sheets must be at the right-hand side. When an external finisher is connected
to the machine, it is possible that you must put the media into the paper trays in a different
way. Refer to the documentation of the external finisher for more information about how
to place the media.
When to do
The 'Schedule' displays a red bar next to a required media. The red bar indicates that
a scheduled job now requires a media that is not available in the paper trays.
The 'Schedule' displays an orange bar next to a required media. The orange bar indi-
cates that, in the future, a scheduled job requires a media that is not or not sufficiently
available in the paper trays.
The current job requires more of the same media than currently loaded in the paper
trays. You can add more of the required media into another paper tray.
You already want to load and assign media that are required for the next job (work
ahead).
Note:
Always put the stack of media at the left-hand side of the paper guides inside the paper
trays, as indicated on the sticker inside the paper trays.
Note:
When the finisher is the output location of your jobs, then you must put the oriented
media face down, header up into the paper tray.
48 Chapter 4 - Work with the operator panel