Oce VarioPrint 4110 User Manual page 163

Note:
A number indicates the order in which the subsets have been scanned.
When all subsets have been scanned, press 'Ready'.
8.
A full overview of all the scanned subsets appears in the right-hand pane. If required, you
can still adapt the job:
Add another subset (see
Insert a subset (see
Delete a subset (see
Edit a subset (see
When the job is OK, start the creation of the file (see
9.
start the creation of the file' on page
Add a subset
Put the subset into the automatic document feeder or on the glass plate.
1.
In the preview pane, press 'Add'.
2.
The settings pane becomes available.
Define the settings for the new subset.
3.
Press the Start button .
4.
The new subset is added to the end of the list of subsets.
Repeat the steps 3 and 4 if you want to add more subsets, or press 'Ready' when all the
5.
additional subsets have been scanned.
The full overview of all the scanned subsets appears.
When the job is OK, start the creation of the file (see
6.
start the creation of the file' on page
Insert a subset
Put the subset into the automatic document feeder or on the glass plate.
1.
In the preview pane, select the subset below the position where you want to insert a subset.
2.
Press 'Insert'.
3.
The settings pane becomes available. Furthermore, an empty line appears above the se-
lected subset.
Define the settings for the new subset.
4.
Press the Start button .
5.
Repeat the steps 4 and 5 if you want to insert more subsets after the new subset, or press
6.
'Ready' when all the additional subsets have been scanned.
'Add a subset' on page
'Insert a subset' on page
'Delete a subset' on page
'Edit a subset' on page
164).
164).
Combine subsets into one file
163)
163)
164)
164).
'Define the general parameters and
'Define the general parameters and
Chapter 4 - Work with the operator panel 163