Table of Contents
Advertisement
From the list of media, select the media that will be used as the media the controller is
2.
asking for and press 'OK'.
Note that this might be an incorrect media.
The media will now be displayed with the name that is defined in the media catalogue.
Select the paper tray where you want to load the required media and press 'OK'.
3.
Load the media.
4.
Close the paper tray.
5.
Press 'OK'.
6.
Now you can assign other media or continue the print job.
How to handle the 'Media message' in the tray-to-media mode
A message on the operator panel indicates that a media is missing. Select one of the fol-
1.
lowing actions as a response to the message.
Press '<HTML><center>Assign media</center></HTML>'.
Continue with step 2 when you select this option.
Press 'Continue'.
The controller will use the PCL default media and continue the print job.
Note that this might be an incorrect media.
Press '<HTML><center>Cancel stream</center></HTML>'.
The print job is stopped. You can now solve the problem. It is most likely that you
can solve the problem on the server.
Note:
The following steps apply only when you chose to assign a media.
From the list of media, select the media that will be used as the media the controller is
2.
asking for and press 'OK'.
Note that this might be an incorrect media.
Select one of the 16 memory locations of the logical-tray table to be used for the required
3.
media.
Note that the media that was previously allocated to that memory position in the setup
will be overwritten. Then that media will no longer be available to the transaction stream.
Now you can assign other media or continue the print job.
Handle the media messages
Chapter 4 - Work with the operator panel
215
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
