Change The Warning Time - Oce VarioPrint 4110 User Manual

Change the warning time

Change the warning time
Introduction
When operator interaction is required now or soon, the dashboard (see
on page 42) can display a warning message. The message informs you about a required
upcoming action, for example load a required media type or empty an output location.
You can define how long in advance the warning message is displayed. By factory default,
the function 'Warning in advance' is enabled and set to 10 minutes. Then the dashboard
starts to display the warning 10 minutes before an action becomes inevitable. If you do
not respond to the warning message, the printer will stop. Depending on the urgency of
the warning message, the vertical bar in the dashboard is orange or red.
This section describes how to change the warning time. This section also describes how
to disable the function 'Warning in advance', in case you do not want to use the warning
function.
Note:
The operator attention light (see
the status of the machine. For example, when the dashboard displays an orange warning,
the orange light of the operator attention light also lights up.
Set the warning time
On the operator panel, press the 'System' button.
1.
Press 'Setup'.
2.
Press the 'Warning time' button in the 'User interface' section.
3.
186 Chapter 4 - Work with the operator panel
'The operator attention light' on page
'The dashboard'
30) is linked to