Oce VarioPrint 4110 User Manual page 123

Note:
If you want to insert another subset at another position, you must first press 'Ready' and
then repeat the steps 1 to 5.
The full overview of all the scanned subsets appears.
When the job is OK, start printing (see
7.
on page 123).
Delete a subset
In the preview pane, press the subset you want to delete.
1.
Press 'Delete'.
2.
When the job is OK, start printing (see
3.
on page 123).
Edit a subset
In the preview pane, select the subset you want to edit.
1.
Edit the settings.
2.
Note:
The settings you can edit become available. All the settings you cannot change are greyed
out.
When the job is OK, start printing (see
3.
on page 123).
Define the general parameters and start printing
When the job is OK, press 'Ready'.
1.
Define the parameters, like the number of sets. These values apply to the whole copy job.
2.
Press the Start button
3.
'Define the general parameters and start printing'
'Define the general parameters and start printing'
'Define the general parameters and start printing'
to start printing.
Chapter 4 - Work with the operator panel
Combine subsets into one document
123