Oce VarioPrint 4110 User Manual page 207

Num-
ber
2
3
4
Sequence of steps for transaction printing
The following table describes the sequence of steps for transaction printing in general.
#
Actions at the printer side
1. Switch the printer into the transaction
printing mode
2. Select the required job setup via the
operator panel. You must define the
properties of the job setup in the Settings
Editor application on the Controller
3. Load the required media into the paper
trays
4. Put the printer on-line
7. Print the transaction stream
Note:
You must perform all the regular
activities, for example load the
media, empty the output loca-
tions, add the supplies and solve
errors
Item
'Connection'
'Print protocol'
'Image shift'
Introduction to the 'Transaction' section
Function
The 'Connection' section gives access to the follow-
ing functions.
Turn the transaction printing function on or
off
Put the printer on-line. This is required to
connect the printer to the server
Select the setup for the transaction stream
Display the active printer description language
(read-only)
Display and change the image shift
Actions at the server side
5. Connect to the printer
6. Start the transaction stream
Chapter 4 - Work with the operator panel 207