Change The Output Location - Oce VarioPrint 4110 User Manual

Change the output location

Change the output location
Introduction
Note:
This section applies to changing the settings of a print job or copy job that is already
available in the list of 'Waiting jobs' or 'Scheduled jobs'.
In the Settings Editor, you can set the default output location for print jobs. However,
you can change the output location on the operator panel for each job individually. De-
pending on the configuration of your system, you can select one of the following output
locations.
Finisher upper output
'Finisher'
'Stacker'
Stacker/stapler
Stacker/stapler upper output
'External finisher'.
This section describes how to select another output location for a specific job.
Note:
There must be a match between the selected output location and the job requirements.
For example, when a job does not require staples, you can select any output location.
When a job requires 1 or 2 staples, you can only select the output locations that can
staple the jobs, for example Finisher or External finisher because the Stacker cannot
staple the jobs. When you make a combination that is not possible, the operator panel
displays an error message.
86 Chapter 4 - Work with the operator panel