Load The Paper Trays - Oce 2090 User Manual

Load the paper trays

Introduction
Task for operators, key operators
The Océ VarioPrint 2090 has 4 front-loading paper trays. All 4 paper trays can
handle the same variety of copy materials (see 'Materials that can be used' on
page 174). You can add paper to the paper trays while the printer is running.
When a paper tray is empty, the Océ VarioPrint 2090 automatically switches
to another paper tray that contains the same paper.
The Océ Settings Editor contains the setting 'Paper tray locking'. The 'Paper
tray locking' function is an electronic lock on the paper trays. The key operator
can define in the Océ Settings Editor that the setting 'Paper tray locking' must
be 'On' or 'Off'.
See the on-line help of the Océ Settings Editor for more information
Note:
about the 'Paper tray locking'.
When to do
You must load paper in the paper trays in the following situations.
The paper tray is empty.
The print job needs a special paper type.
The print job needs covers or 'My Paper'.
The paper tray does not contain the correct paper type.
You can check the status of the paper trays on the operator panel. You can find
the information in the 'System monitor' of the 'System information' section (see
'The 'System information' section' on page 32).
You can also check the LED on the paper tray to see which paper tray is empty.
The LEDs on the paper trays are off when the trays are full. When a paper tray
runs empty, the LED blinks.
When the setting 'Paper tray locking' is enabled, a PIN code is required
Note:
each time the paper trays are unlocked. The key operator must enter the same
PIN code that is used to access the key operator settings in the Océ Settings
Editor. Then you can refill the paper trays. Remember to lock the paper trays
after you load the paper.
150 Océ VarioPrint 2090 User manual