Punch or staple the output
Illustration
[81] Punch or staple the output
Punch or staple the output
Put the originals face down and in readable form into the automatic document feeder.
1.
On the operator panel, press the 'Copy/Scan' button.
2.
Press 'Copy job' or 'Combined copy job'.
3.
In the 'Output' pane, press 'Finishing' or 'Staples' (see the above Note).
4.
In the 'Staples' setting, select the required number of staples.
5.
In the 'Punch' section, select 'Yes' to punch the output.
6.
If required, define the other settings for the original document and the output.
7.
Enter the generic parameters in the 'Job' section.
8.
Press the Start button .
9.
134
Chapter 4 - Work with the operator panel