Oce VarioPrint 4110 User Manual page 242

Troubleshooting
Clear a paper jam
Open the front door of the puncher.
1.
Check if the chip tray is not too full.
2.
Follow the steps in the table.
3.
#
Area
242 Chapter 6 - Optional finishers
Description
Check the bypass:
Lift lever K1.
Check for jammed media in the bypass, the entrance guide
(1) and the diverter (2).
Check the downward paper path:
Open latch K2.
Check for jammed media.
If necessary, turn knob K2 anti-clockwise until the paper
falls down.
Check the die set:
Turn knob K3/K7 clockwise until the puncher is in the
home position. Then the black lines on the knob (3) and
the frame are aligned.
Slide the die set out.
Check for jammed media.
Put the die set back.
Check the bottom of the paper path:
Press lever K4 inward and lower the U-channel.
Check for jammed media.
If necessary, turn knob K4 until the paper falls down.
Check the upward paper path:
Open latch K5.
Check for jammed media.
If necessary, turn knob K5 clockwise until the paper falls
down.