Table of Contents
Advertisement
Check the first set
Check the first set
Introduction
Note:
This section applies to changing the settings of a print job or copy job that is already
available in the list of 'Waiting jobs' or 'Scheduled jobs'.
You can indicate that you want to print 1 set of a job first to check the print quality.
When the print quality meets your expectations, you can continue the job.
You can use 1 of the following methods to indicate that you want to check the first set.
Use a workflow profile where 'Check first set' is enabled (see
profiles' on page
printed. The machine goes on hold after 1 set is printed.
Enable the function 'Check first set' in the 'Properties' option of the 'Jobs' view for a
specific job only. However, this only works when the setting 'Check first set' in the
workflow profiles is set to '<html>As in job</html>' (see
profiles' on page
This section describes how to indicate that you want to check the first set for a specific
job only.
Note:
When you use the function 'Check first set', the printed set is subtracted from the indi-
cated total number of sets for a job. For example, when you need 10 sets, the machine
will print the first set and then stop. When you continue the job, the 9 remaining sets
are printed. This is different from the making of a proof (see
80
Chapter 4 - Work with the operator panel
179. Then the machine always prints 1 set before the entire job is
179).
'Work with the workflow
'Work with the workflow
'Make a proof' on page
66).
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
