Load A Media Roll - Oce ColorWave 500 Operation Manual

Load a media roll

Load a media roll
Introduction
You can load standard and custom media on your printer.
Before you begin
Before you load a roll on the printer, make sure your media has been configured.
• For standard media you can configure and enable a media profile in Océ Express WebTools.
For more information, see
• Make sure the size is configured and enabled in Océ Express WebTools. For more information,
see Configure the media sizes on page
create a custom media size. For more information, see
page 170.
IMPORTANT
• Do not use dented media rolls to prevent damage to the imaging devices.
• Do not open the media drawer during the print process.
• Do not open more than one media drawer at the same time to prevent overbalance of the
printer.
CAUTION
Watch your fingers when you handle the media roll.
Procedure
1. Pull firmly to open the media drawer.
2. Place the new media roll on the roll loading station.
3. Pull (1) the handle of the roll holder locking mechanism toward you.
Slide (2) the roll holder into the right side of the core of the new media roll.
264 Chapter 5 - Maintain the Printing System
Configure the media profiles on page
171. If your media size is not present in the list, you can
168.
Create a custom media size on